Welcome! Log In Create A New Profile

Advanced

RAMPS 1.4 test code not working for Z-axis

Posted by patxystage1 
RAMPS 1.4 test code not working for Z-axis
May 08, 2017 12:47PM
Hello,

My Z-axis motor is not moving when I run the RAMPS 1.4 test code. I have verified that the motor drivers are not the cause. I have also used a multimeter to check the voltages coming out of the DIR, STEP and VMOT pins. When comparing the voltages from these pins on the Z and X axes (which works), they are identical. Any suggestions would be much appreciated.
Sorry, only registered users may post in this forum.

Click here to login