Welcome! Log In Create A New Profile

connection of steppers and ramps

Posted by balha

balha

connection of steppers and ramps
April 08, 2017 03:10PM

Registered: 7 years ago
Posts: 2

Hello everybody

i have a stepper with 5 wires and i`m wonder how to connect this motor with ramps because ramps contain only 4 pins

5wire.GIF

Edited 1 time(s). Last edit at 04/08/2017 03:11PM by balha.

Reply Quote

dc42

Re: connection of steppers and ramps
April 08, 2017 03:50PM

Registered: 10 years ago
Posts: 14,672

You need to take the stepper motor apart so that you can separate wiring for the two phases. But before you do that, check the voltage and current requirement of the stepper motor. It's very likely that it requires too much voltage to work well with any electronics that uses constant current stepper drivers.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

o_lampe

Re: connection of steppers and ramps
April 09, 2017 02:08AM

Registered: 8 years ago
Posts: 5,232

If it is a 28BYJ-xx stepper, the picture shows where to cut the track.