I recently purchased a CR-10 printer and it came with a Melzi board and a "RepRapDiscount Full Graphic Smart Controller" but without SD card reader so it only has 1 connector to it. I am changing out my Melzi board with a MKS Gen 1.4 board and I would like to use the stock display connected to EXP1 on the MKS board but I can not get it to work. I have uncommented the line in code for the display and I even rotated the connector on the display and I got the display to turn on but it just shows a "blank" screen. What else is there that I can do to make this work? I am trying to use the latest Marlin FW if that help.
TIA!
Edited 1 time(s). Last edit at 03/24/2017 05:09PM by Prometheus-3D.
