Ramps1.4 with 24V power supply and Adruino DUE ?

Hi.

I need help with electronics for delta printer that includes:
- 24v nema 17 engines (400 steps)
- DRV8825 (1/32 microstep)
- 24V heatbed
- 24V hotend

I plan to modify Ramps 1.4 (unsolder D1 diode, change fusses) and plug in 24V 15A power supply.
Power on arduino with usb cable.

My question:
Is there any modifications that i need to do with ramps 1.4 to use 24V power supply ?
Can I use Arduino DUE with ramps1.4 (with unsolder D1 diode) ?

Thank you for your time and effort in helping me.

Edited 4 time(s). Last edit at 12/27/2016 07:49AM by asrt.

See Andrew's thread about modifying a standard RAMPS for use with Arduino DUE.

You also need to check the voltage rating on the capacitors under the DRV8825 modules. A lot of boards use 16v caps.. You need a 32volt caps.

I would also replace the heated bed mosfet with a IRLB 8743