Welcome! Log In Create A New Profile

Advanced

altering repsnapper to directly adjust esteps per mm

Posted by Chaacman 
altering repsnapper to directly adjust esteps per mm
November 06, 2012 03:15PM
I know its kind of a goofy question but I was wondering if anyone has tried to add a direct Extruder esteps per mm adjustment control to any version of repsnapper or any of the host softwares could be made to do this?
Re: altering repsnapper to directly adjust esteps per mm
November 13, 2012 02:42AM
If your firmware supports it, the gcode M92 with an E parameter can do this. The host software only need a way to send gcodes manually then (repsnapper can).


Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.
Re: altering repsnapper to directly adjust esteps per mm
December 05, 2012 07:20AM
Try with Extrusion Multiplier in Printer settings and convert to Gcode

Extrusion Multiplier - 1 denotes actual length
Extrusion Multiplier - 0.5 denotes 50 % of actual length

If your Machine Extrusion is calibrated wrong try with Firmware modification
else for temporary change you can use Extrusion Multiplier
Sorry, only registered users may post in this forum.

Click here to login