Huxley duo wiring loom

I have just about completed a Huxley duo but have a problem connecting the proximity sensor. The red and blue wires appear to be reversed when compared with the picture in the documentation. Its then not possible to insert the plug into the expansion socket on the board. So either the picture and diagram are wrong or the loom has been assembled incorrectly. Please could somebody confirm which is correct, I assume the documentation is but I don't want to ruin the board by reversing the wires if I'm wrong!

Many thanks

Ha, same problem here except in mine the yellow and green are reversed. I emailed support but no response yet. Trainee on the manufacturing line?

I did get a reply eventually. Apparently RepRapPro had problems with their email.

Some looms were sent out with the wires crossed. The correct connections are as shown in the manual pictures. It's fairly east change the wires round. You just need a fairly fine screwdriver to push the ins out.

Regards

Peter