Power

Heey everybody,

Im searching for a power supply for my reprappro huxley. Im almost done with the wiring part of the tutorial so i hope to have it soon. The problem is i cant find what kind of connector they use (the one with the positive in the center and the 2 negative on the outside) from this page:

[reprap.org]

Also i have no idea what kind of power supply it needs. the tutorial says 19V and thats it. So will every 19V power supply do?

Thanks!

Power supply must have 6 A output at 19V. See attachment...

Thanks you! that helps a lot.

And do you know the name of the connector?
[reprap.org]

I cant find it...

Dont understad? Input connector from wall to power supply is normal 110-220V cable which you will get with power supply. And output connector I cut it and replace with normal male/female power supply wire from computer because they original connector is to flimsy and not robust at all for me and it sparks when I plug power in. And power cables for Melzi and heat bed board are to stiff. You dont need they original connector at all.

Edited 1 time(s). Last edit at 07/03/2013 11:21AM by Suljo.

So when i order a powersupply i receive the connector with it? I dont really understand what you mean...

Thx

You will get what you see in my first attachment, male connector.
But you dont get female connector from you link
Female conector from Huxley

Anyhow you dont need this female connector at all se my last post.

Oke thank you for the information!