Welcome! Log In Create A New Profile

reprappro huxley heat bed temperature not setting

Posted by smartdev

Forum List Message List New Topic

smartdev

reprappro huxley heat bed temperature not setting
February 09, 2013 06:22AM

Registered: 11 years ago
Posts: 11

Ok so I have just finished building my huxley and have my first issue smiling smiley

The heated bed temperature just goes up and I am unable to control it with the softwware. I have checked continuity between the second pin in and the pin that it sonnets to on the melzi board and this seems fine. any ideas?

Reply Quote

nophead

Re: reprappro huxley heat bed temperature not setting
February 09, 2013 08:21AM

Admin
Registered: 17 years ago
Posts: 7,879

Are you using the correct firmware?RepRapPro are the only people that drive their bed from that pin. I think they have their own version of the firmware.

[www.hydraraptor.blogspot.com]

Reply Quote

smartdev

Re: reprappro huxley heat bed temperature not setting
February 09, 2013 11:37AM

Registered: 11 years ago
Posts: 11

I am using the preloaded firmware, I shall try updating it though thanks.

Reply Quote

smartdev

Re: reprappro huxley heat bed temperature not setting
February 09, 2013 12:11PM

Registered: 11 years ago
Posts: 11

Hmm, I have updated firmware. Maybe there is a fault with the bed?

Reply Quote

smartdev

Re: reprappro huxley heat bed temperature not setting
February 09, 2013 12:32PM

Registered: 11 years ago
Posts: 11

Sorted it, like a complete idiot I got the polarity incorrect going to the board..