Hi all,
Below is an article written recently on the safety of PLA when used as a 3D printing filament. Would anyone here have any other points the can think of that could be added to the list off the top of their heads?
Also, did you find the article helpful. Any criticism is welcome and appreciated.
E.g.
Did you find the report helpful?
(1) Yes, there were many things outlined that I was previously unaware of.
(2) No, I found it to be fairly predictable and learned nothing new.
(3) Yes, but it could have been better written.
(4) No, and please don't post content like this again.
(5) I had no strong feelings either way.
Artice:
[
www.ink3d.ie]
