Hi all,
I have a few quick questions:
1) Does the reprap firmware (more specifically DC42 fork) buffer multi-pal lines of Gcode?
2) What's the best way to send the gcode; Send G command wait for an 'ok' response send next command and so on...?
3) I would be grateful for any tips and/or advice.
Background...
I am writing a small console to use with my 6DOF/axis printer, time is very limited: so simplicity is key. I have tried using: pronterface, replicatorG, chrome sender, duet web control, mach3. None of which are working with my sliced 6DOF gcode; each has a factor that will prevent my custom Prusa from printing.
Thank you
Dave
PS I know very little about the communication protocol, I am assuming this fork does not look ahead like marlin.