Modifying Prusa i3 for syringe pump

I'm trying to build a 3D Printer that will print a self curing silk/glycerol solution for scaffolding purposes. So i figured i'd try to build a Prusa i3 and replace the extruding device with a syringe pump (most likely following this design--->[www.appropedia.org]) but I'm not sure how to to do the circuitry or what to change in the arduino code. Im using Arduino Megan and RAMPS 1.4 with drivers.

-How would i connect the syringe pump motor to the RAMPS?
-im using the Marlin Firmware-how can i adjust the coding for no thermal components but just the syringe pump?
-is there any open source coding out there for a similar design?

Would really appreciate some help
thanks

... you can use the pins and drivers for the extruder motor and you can even use a syringe heater in the same way, as with the normal hot-end - you have only to adjust/calibrate the steps per mm accordingly and set the temperature for the 'hot-end' ...

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

why not try this kit [reprappro.com]

---

RepRapPro China 技术支持团队

西安锐普3D打印机有限公司
www.reprappro.com.cn