Welcome! Log In Create A New Profile

Advanced

Ninjaflex - Heated Bed?

Posted by ByteSlinger 
Ninjaflex - Heated Bed?
April 18, 2016 05:18AM
I'm looking to print with Ninjaflex on my Fisher but wanted to check peoples opinions/experiences printing it without a heated bed.
Am I going to run into endless problems or should it be ok?
Re: Ninjaflex - Heated Bed?
May 16, 2016 11:11PM
You must squeeze it very well on the bed and print the first layer slowly, but it is definitely doable, at least on glass + PVA glue.
Sorry, only registered users may post in this forum.

Click here to login