So I recently soldered together some gen 7 v1.5 electronics. The board was purchased through Traumflug. I started running through the checks
here. The standby (yellow) led turns on just fine when I plug in the PSU. However, when I short the standby (green) wire of the PSU the best I could do was get the fan to spin up for a second and then it just shut off again. The green LED (bottom right corner) turned on for this long as well. All the voltages on the ATmega slot measured as expected.
Just to try something else, I burned the bootloader and
this diagnostic program onto my chip. I put the chip on the board and the fan+LED only get a quick blip of power. The serial communication is working fine during the diagnostic program.
I don't know if it's of any help, but a picture of the board is
here.
Thanks for any help.
Edit: I meant to add that I've tried 2 power supplies.
Edited 1 time(s). Last edit at 03/09/2013 04:27PM by Glow.