I supose there are pins for all of this, but both the stepper and heater need 12V, right?
|Generation 7 Electronics||Teacup Firmware||RepRap DIY|
PC2 (D18) -> Edir* PC4 (D20) -> Estep PD5 (D13) -> Heat_Ext PA7 (AI 7 / D24) -> Temp_Ext
Is there sufficient place to mount a heatsink onto your mosfet?
Looks good! I guess the motor header is a bit too close to to the Pololu (you need space to allow the friction ramp to work), but that's easily solvable. I've put a link into Gen7's wiki page.
Partier SPRe: Gen7 Dual Extruder
April 19, 2013 12:44AM