Welcome! Log In Create A New Profile

Advanced

Help! New delta G28 doesnt home. But moves all motors about 10mm opposite way

Posted by Jmtech 
Help! New delta G28 doesnt home. But moves all motors about 10mm opposite way
July 25, 2017 12:05PM
Hi! Got a new delta. Loved the build. Its an Anycubic plus.
Problem im having.
When i send Home to the printer (code or on the interface). It doesnt go up. It goes down. But it doesnt try to home. Each motor in turn lowers a few mm. Then if i press it again, the same thing happens?
Re: Help! New delta G28 doesnt home. But moves all motors about 10mm opposite way
July 25, 2017 12:26PM
Endstops report triggered even though they're physically not? Maybe run M119 and see?
Re: Help! New delta G28 doesnt home. But moves all motors about 10mm opposite way
July 25, 2017 12:29PM
Wow. Çheers! Z min open. X y and z max triggered.... how bizarre.

Most likely cause?

Firmware is preconfigured by the supplier.... but wonder if its wiring or config....

Thanks in advance

J
Re: Help! New delta G28 doesnt home. But moves all motors about 10mm opposite way
July 25, 2017 12:39PM
All triggered. Wiring issue. Im such a tool. Did it according to the board instead of the config. Doh!

Life saver!
J
Sorry, only registered users may post in this forum.

Click here to login