Welcome! Log In Create A New Profile

Advanced

Help! Delta refuse to get closer then 1mm to the bed

Posted by SlowFoot 
Help! Delta refuse to get closer then 1mm to the bed
July 25, 2017 11:25AM
I am trying to get my delta up and running and it is getting close but not quite close enough.
I run RAMPS on Repetier 1.0dev. Auto-calibration works (Thanks obewan!), delta adjusted and the extruder is calibrated.
But it refuses to get the nozzle closer to the bed then 1mm. If I jog it, it simply stops moving at Z=1 and if I run a print it will pause at first move to the bed. If I unpause the print it will extrude a mm over the bed. I use a 3mm block to check Z height, and it is ok.
I guess some setting somewhere is off a mm.
Any suggestions ?
Sorry, only registered users may post in this forum.

Click here to login