Hi everyone, I'm new to this forum. I just joined because I just built a Flsun delta printer and I can't get it to work. Here's the story: build printer, upload Marlin firmware with delta configuration file provided by the manufacturer. so what does work: using manual controls on the Repetier Host (not the on lcd panel) I've got the homing function to work after inverting all the servo directions in the firmware, at first when selected it moved the extruder towards the bed. The x, y and z manual controls do not work as desired. Z control does nothing except a small clicking noise and the x and y controls are completely unpredictable. One manual selection (I'm not sure if it was x or y) sent one arm up towards the limit switches and the other two towards the bed until they jammed. I stopped it using the emergency stop. I'm completely stumped. I'm I missing something, is it a hardware failure, I just can't figure it out. Any suggestions would be appreciated. thanks! Using Arduino 1.8.1. Board: Mega 2560. Programmer: USBtinyISP. Printer board: MKS Gen_L V1.0. Thanks again