Hello all,
I have a Kissel XL that was perfectly calibrated up until about a week ago. The bed probe seems to be going through its routine but seems to be off by about an inch. It is has gotten so bad that when it goes through its centre configuration it goes off the heat bed. Is there a way to let the firmware know that it is off centre by re entering in a starting point or do I need to configure the path with an -1 inch offset to bring it back to centre? Sorry for the itchy vocabulary but I am not quite sure how to explain this with the proper wording. I had someone configure it for me as I am not the best with the programming side of the printer. Please let me know how to proceed.
Thank you for your patience in helping me through this.
