Hi,
i bought a Sintron Kossel Mini.
It seems to have some changes in design - i have no blocking issue if i move something by hand.
However i have a big problem getting the thing to print anything.
I tried to use a new Marlin firmware and a x2sw package with pronterface. (With original firmware the thing does not sseem to respond after 2 or 3 commands).
Both in firmware and in pronterface i chossed delta / round table.
M106 turns on the fan and in pronterface the extrect retract and temperature button of the extruder seem to work. The temperature of the build plattform also increasess - the display also shows a higher tempereature but not pronterface - it keeps 19°.
If one of the carriages hit an endstop the endstop lights up.
But now i don't know how to continue. It does not seem to make an x/y movement if i choose so in the software. Best it does is to move one single carriage - and that only up to ~ 8 cm.
As other people already get this thing to work - is there anyone who can provide a working firmware? Either Marlin or Repetier?
What am i possible doing wrong?
