Welcome! Log In Create A New Profile

Err: MINTEMP in a delta Kossel printer

Posted by mga

mga

Err: MINTEMP in a delta Kossel printer
December 29, 2016 07:34AM

Registered: 7 years ago
Posts: 256

I have a Kossel delta changed. I mounted an extruder 3 in 1. When I turn are read two strange temperature: 22 ° is on the heatbed and on the extruder. Since the minimum temperature should be 5 ° I do not know what it is. I checked all the single connections.

Reply Quote

o_lampe

Re: Err: MINTEMP in a delta Kossel printer
December 29, 2016 10:59AM

Registered: 8 years ago
Posts: 5,232

A MINTEMP error is a sign for a shortcut in the thermistor wires. Often it is the setscrew pushing to hard against the sensor or the ptfe tubes on the sensor wires are not intact.

Reply Quote

mga

Re: Err: MINTEMP in a delta Kossel printer
January 02, 2017 09:47AM

Registered: 7 years ago
Posts: 256

I do not think my case if I unplug the thermistor does not read anymore, but if I see riconnetto 22 ° is on the hot bed that on the thermistor. Perhaps it is a firmware error, but do not know how to correct it

Reply Quote

o_lampe

Re: Err: MINTEMP in a delta Kossel printer
January 02, 2017 04:17PM

Registered: 8 years ago
Posts: 5,232

If you read 22° on both thermistor inputs ( bed and hotend ) but only have one thermistor attached, it is a shortcut between the sensor input pins.

Reply Quote

mga

Re: Err: MINTEMP in a delta Kossel printer
January 03, 2017 08:06AM

Registered: 7 years ago
Posts: 256

I have two thermistors and both correctly read the temperature with slight variations from one another, but still get the error MINTEMP inexplicably. And the printer for this reason work not.