Welcome! Log In Create A New Profile

No speed in Rostock

rostock78

No speed in Rostock
October 27, 2016 01:47PM

Registered: 7 years ago
Posts: 2

Hallo,
i,m new tot this forum.
I have a problem, hopefully someone can help me.
Recently i finished the building of a Rostock according to this site.
Until now it looks okay ( trail and error). The steps looks according to the movements.
Only one problem the movements are very slow, much to slow.
I,m using Repetier firmware and Repetier Host.
Can somebody give me the parameters wich he is using ?
Thanks!

Reply Quote

Kurzaa

Re: No speed in Rostock
October 28, 2016 03:36PM

Registered: 9 years ago
Posts: 569

You might try looking at Greeetech's website which appears to have a Rostock printer. Also consider checking out the SeeMeCNC Rostock Max forums, which will hopefully get you to a good starting point for your settings.

Sadly, I have moved onto 32-bit boards, so I can't offer much advice. Good luck.

Reply Quote

hercek

Re: No speed in Rostock
October 29, 2016 05:33AM

Registered: 10 years ago
Posts: 732

Just open Repetier Host (or issue m205 command if you do not use Repetier Host), and check carefully the calibration parameters. You probably have set maximum speed to a small value, or acceleration is very small.