Questions About DC42 Kossel. July 31, 2015 07:27PM |
Registered: 9 years ago Posts: 27 |
Re: Questions About DC42 Kossel. July 31, 2015 10:24PM |
Registered: 9 years ago Posts: 6 |
Re: Questions About DC42 Kossel. August 01, 2015 04:10AM |
Registered: 10 years ago Posts: 14,672 |
Re: Questions About DC42 Kossel. August 01, 2015 07:56AM |
Registered: 9 years ago Posts: 27 |
Re: Questions About DC42 Kossel. August 01, 2015 10:31AM |
Registered: 10 years ago Posts: 14,672 |
Re: Questions About DC42 Kossel. August 01, 2015 12:58PM |
Registered: 8 years ago Posts: 445 |
Quote
dc42
I have just published a new blog entry describing some upgrades to my Kossel derivative, including 0.9 degree/step motors. It's at [miscsolutions.wordpress.com].
Re: Questions About DC42 Kossel. August 01, 2015 02:32PM |
Registered: 10 years ago Posts: 14,672 |
Quote
Koenig
The 0.9 motors seems to increase the surface quality quite a bit looking at the pictures, would 1/32 steppers make the same difference?
Quote
Koenig
I can tell you that the motors from steppersonline does not a D-cut shaft either, but they were really quick to deliver them!
Re: Questions About DC42 Kossel. August 01, 2015 03:09PM |
Registered: 8 years ago Posts: 445 |
Quote
dc42
Quote
Koenig
The 0.9 motors seems to increase the surface quality quite a bit looking at the pictures, would 1/32 steppers make the same difference?
1/32 drivers might make some difference on 1.8deg motors, but probably not as much. Microsteps are less accurate than full steps, and the incremental torque for a 1/32 step on a 1.8deg motor will be around half the incremental torque for a 1/16 step on a 0.9deg motor.
Quote
Koenig
I can tell you that the motors from steppersonline does not a D-cut shaft either, but they were really quick to deliver them!
Which model of motor did you buy? These [www.omc-stepperonline.com] show a D-cut shaft in the image. Did yours have flying leads, or a JST connector?
Re: Questions About DC42 Kossel. August 02, 2015 02:37AM |
Registered: 10 years ago Posts: 14,672 |