Extrusion Issues July 26, 2015 02:59PM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues July 26, 2015 04:11PM |
Registered: 9 years ago Posts: 346 |
Re: Extrusion Issues July 26, 2015 04:40PM |
Registered: 10 years ago Posts: 14,672 |
Re: Extrusion Issues July 26, 2015 04:45PM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues July 26, 2015 05:00PM |
Registered: 10 years ago Posts: 14,672 |
Re: Extrusion Issues July 26, 2015 05:08PM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues July 26, 2015 05:23PM |
Registered: 10 years ago Posts: 14,672 |
Re: Extrusion Issues July 26, 2015 05:35PM |
Registered: 9 years ago Posts: 346 |
Re: Extrusion Issues July 26, 2015 06:18PM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues July 26, 2015 07:40PM |
Registered: 9 years ago Posts: 346 |
Re: Extrusion Issues July 27, 2015 02:08AM |
Registered: 8 years ago Posts: 445 |
Quote
LarsK
Then install the nozzle so it has full contact to the heating block, then screw in the heatbreak - when installing the heatbreak wrap it at the heating block side with PTFE tape (like you would seal a pipe). When screwing it in pay attention that it is very important that your nozzle and heatbreak end up meeting each other.
Re: Extrusion Issues July 27, 2015 02:21AM |
Registered: 10 years ago Posts: 14,672 |
Re: Extrusion Issues July 27, 2015 08:32AM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues July 27, 2015 09:02AM |
Registered: 10 years ago Posts: 14,672 |
Quote
Freebird01
i had (2) - 40mm fans bolted to the end effector but ive reduced it to one...neither seemed effective since its not ducted around it like the clip on 30mm fans.i plan on changing my design to allow for this now that im seeing the issues. and yes...I have it set in slic3r in the custom code that it turns the fan on full throttle before it turns on the heaters.
Re: Extrusion Issues July 27, 2015 09:18AM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues August 20, 2015 05:45PM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues August 20, 2015 05:53PM |
Registered: 10 years ago Posts: 14,672 |
Re: Extrusion Issues August 20, 2015 05:55PM |
Registered: 8 years ago Posts: 70 |
Re: Extrusion Issues August 20, 2015 05:58PM |
Registered: 10 years ago Posts: 14,672 |