Welcome!
Log In
Create A New Profile
Home
>
Machines Organized by Style
>
Delta Machines
> Topic
Advanced
Autolevel start location on the bed
Posted by
MarkIngle
Forum List
Message List
New Topic
MarkIngle
Autolevel start location on the bed
July 24, 2015 05:11PM
Registered: 8 years ago
Posts: 31
I have auto level working but I am not sure it is working correctly. When the probe touches the bed its pretty much in the middle of the bed and starts moving toward the front. Seems like it should start somewhere near the rear. Struggling!!!!
Reply
Quote
mikes3ds
Re: Autolevel start location on the bed
July 24, 2015 06:35PM
Registered: 9 years ago
Posts: 76
What controller do you use or what 3d printer are you using? (Front is relative, I would go based off of towers.)
Reply
Quote
MarkIngle
Re: Autolevel start location on the bed
July 24, 2015 08:35PM
Registered: 8 years ago
Posts: 31
Kossel with Arduino and RAMPS. The probing goes toward the x any y towers.
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login