Guys
I am looking for inspiration here.
I am getting quite a bit of very hairy stringing on my fairly new Delta
It is loosely based on a Kossel but is 1 mtr tall with 500 mm sides
I has DUET controller with a DC42 Mini Sensor board and that is fine
I has a E3D V6 Lite hotend which extrudes really easily and I think I have cured the Blobbing that I was getting however I now get these very fine hair like strings.
I am using ESUN Pla for the initial testing (Have also used 3dfilament.ie PLA with same results) and temps currently are 195 bed at 70 retraction is set to 2 mm @ 60 mm/s which is what seems to have stopped the Blobs.
using Slic3r v 1.2.9 stable and also set the automatic speed to max 100 mm/s and 6 mm^3/s Extrusion rate
Photos can be seen at.
Hopefully someone can shed some light onto what I can do to help this issue.
Doug
Have tried reducing 2nd layer and after temps to 185 this seems to be worse!
Edited 1 time(s). Last edit at 06/22/2015 12:11PM by dougal1957.