New release of RepRapFirmware with delta support for Duet electronics January 29, 2015 07:08PM |
Registered: 10 years ago Posts: 14,672 |
Re: New release of RepRapFirmware with delta support for Duet electronics January 30, 2015 05:13AM |
Registered: 9 years ago Posts: 1,159 |
Quote
dc42
I've release a new version (1.00c) of my fork of RepRapFirmware for the Duet here [github.com]. Changes in this release:
* Fixed a problem with step generation that caused one of my delta prints to lean sideways
* Added an experimental simulation mode. This simulates printing without actually doing it, to get an accurate estimate of the print time, taking account of accelerations, speed limits, lookahead etc. The simulation for my 3 hour test print takes less than one and a half minutes, so it can be run while the bed is heating up. Currently, I have provided a temporary interface using M37. Use M37 S1 to reset the simulation time and enter simulation mode. Use M37 S0 to exit simulation mode. M37 by itself gives the number of seconds that the last simulation ran for. I will probably replace this by a simpler interface which takes the name of a file on the SD card that you want to simulate.
* Added the facility to specify the X and Y offsets of the Z probe from the nozzle via the G31 command, for more accurate bed compensation.
The compatible web interface is still version 1.04 available here [github.com].
Re: New release of RepRapFirmware with delta support for Duet electronics January 30, 2015 06:20AM |
Registered: 10 years ago Posts: 14,672 |
Re: New release of RepRapFirmware with delta support for Duet electronics January 30, 2015 06:28AM |
Registered: 9 years ago Posts: 1,159 |
Quote
dc42
Sorry Doug, I didn't make that change. I'll do it now so that it will definitely be in the next release.
Re: New release of RepRapFirmware with delta support for Duet electronics January 30, 2015 06:33PM |
Registered: 10 years ago Posts: 14,672 |
Re: New release of RepRapFirmware with delta support for Duet electronics January 31, 2015 02:58PM |
Registered: 10 years ago Posts: 14,672 |