Hi All,
As said in previous posts I am building a RichRap 3DR, I have printed RichRaps extruder which is 1.75mm but my Prusa i3 is 3mm so I am considering using a 3mm extruder on the 3DR.
I have had a quick look on ThingiVerse for 3mm bowden extruder and was frankly confusedby the number avalable.
So to the questions:
3mm vs 1.75 - Bearing in mind its a bowden setup on a delta printer, what are the advantages and disadvantages of each?
Any recommendations on a 3mm bowden extruder (With a link please
)
Thanks
Z