basculating end effector problem October 23, 2014 06:11AM |
Registered: 9 years ago Posts: 6 |
Re: basculating end effector problem October 23, 2014 12:55PM |
Registered: 10 years ago Posts: 469 |
Re: basculating end effector problem October 23, 2014 07:18PM |
Registered: 9 years ago Posts: 6 |
Re: basculating end effector problem October 23, 2014 08:08PM |
Registered: 10 years ago Posts: 439 |
Re: basculating end effector problem October 23, 2014 08:58PM |
Registered: 9 years ago Posts: 6 |
Re: basculating end effector problem October 24, 2014 10:45AM |
Registered: 10 years ago Posts: 469 |
Re: basculating end effector problem October 25, 2014 01:57PM |
Registered: 9 years ago Posts: 6 |
Quote
jaguarking11
I know this sounds silly, but have you calculated the steps /mm correctly for your particular setup? I would think that the motors are turning a different speed than desired causing wonky movement.
Quote
jaguarking11
Another thing to check would be motor current, make sure your not overloading the drivers and causing missed steps.
One more thing to keep in mind would be acceleration. Make sure your not trying to move it faster than the printer can handle. (I had this when homing at nearly 1200mm/s, I had to lower that a bit and its no longer an issue)