Hi everybody,
I have some trouble on my DIY Delta using the M218 code (with Marlin firmware)
The offset give for the second extruder in the Start Gcode seem to be ignore during the print when my 2 extruder are switched ...
The T2 offset is not apply and print not in the right position.
Somebody using dual extruder on a Delta has good result with the M218 command ?
Thanks in advance for any idea ...
Edited 2 time(s). Last edit at 09/12/2014 03:50PM by Steph ane.
Projet : Delta Reverse, CoreXY
Google+ : [
plus.google.com]
Youtube : [
www.youtube.com]