Thought I would post some pic of my Delta Pi, its nearing the end of its build.
Most of the printed parts have been modified to suit my build.
I am using 20mm sq Stainless steel for the uprights. the print height will go to 550mm, on a 200 x 200 bed.
All the wireing from the top of the printer runs down through the tubes.
I am aiming for this printer to have a very clean look, no rats nest of wiring on show.
The filament is fed through a Bowden feed. The hot end wires will be covered in a black mesh to hide them.
The electronics will be Ariduino and Ramps 1.4 running on Repetier Firmware.