Hello!
I've been going round and round trying to calibrate my printer. I'm running the Latest Marlin. (DELTA)
I have measured my X Y Z (A B C) Towers
I can reach the bed (with a thick piece of paper
TOWERS:
(X) Z1.5
(Y) Z0.6
(Z) Z0
CENTER Z0
---------------
I've tried M666 with out much luck in Repetier Host.
I tried:
M666 X1.4 Y0.6 Z0
G28
G1 X-70 Y-40 Z0 F5000
And the head crashes into the bed. I get the same effect with our without the M666
If I go back to:
G28
G1 X-70 Y-40 Z1.5 F5000 (My X tower, I get level.)
I even tried the reverse:
M666 X-1.4 Y-0.6 Z0
---------------------------
I do not have screws on my carriages so I cant to manual ajustment. Should I just start akking tape to the bottom of my bed?
Thanks!