Bed leveling Delta using Z probe.

Finally got it to work. Using an R/C servo as well. Works great.

The Delta Marlin firmware has an error. You need to use lower case for the function name in Marlin main.cpp. Who ever updated it left that fault in when you enable the R/C servo code.

For the Ramps 1.4 board you have to jumper the VCC and 5V pins just behind the big yellow fuse (if your servo can use 5V, mine does..

The servo is this one on the bay: 160943094668 : SG90 9G servo.

jeffegg2 Wrote:
-------------------------------------------------------
> The Delta Marlin firmware has an error. You need
> to use lower case for the function name in Marlin
> main.cpp. Who ever updated it left that fault in
> when you enable the R/C servo code.

You probably wanted to post this to Marling (or Repetier) issue tracker at their github web pages