Welcome! Log In Create A New Profile

Has anybody used Igus rod ends

leadinglights

Has anybody used Igus rod ends
March 24, 2013 03:58PM

Registered: 12 years ago
Posts: 1,450

I was looking for rod ends and came across the Igus ones - which I assumend would be megabucks, but m3 rod ends come out at about £1.73 each in 25 off quantities - much cheaper than metal ones and not a big jump more than RC car rod ends.

Has anybody tried them? any opinions?

Reply Quote

Duesentrieb

Re: Has anybody used Igus rod ends
October 09, 2013 01:51PM

Registered: 12 years ago
Posts: 8

Almost, if you means Igubal WGRM-05. I ordered some, but they are not delivered yet. I can tell you more when I got them, if this is still relvant to you half a year later.

Regards,
Philip

Reply Quote

ProfessorBean

Re: Has anybody used Igus rod ends
October 11, 2013 02:04PM

Registered: 10 years ago
Posts: 31

lol well now that he has had the opportunity to use and test them, a half a year later,

@leadinglights, what is your opinion on the Igus rods? any good?

Reply Quote

hercek

Re: Has anybody used Igus rod ends
October 11, 2013 05:54PM

Registered: 10 years ago
Posts: 732

... when we are giving really late responses grinning smiley

I did not try Igubal, but MP-Jet works fine (MP JET Ball Link (Ø7 mm, M3, M3 short)):
[www.bigplanes.nl]

Reply Quote

andornot

Re: Has anybody used Igus rod ends
October 15, 2013 03:12PM

Registered: 10 years ago
Posts: 97

Yes i have been testing them for 3 months on my delta printer. Their wear rate depends on what materials and tolerance you fasten them to the carriages. Good for a light weight option and low cost, may wear to quick i will see after my tests.

Andrew