What I am looking for is using the kossel design however I want the foot print to be 4ft diameter.
Which brings questions to what lengths I need my open beam supports to be?
Would I need to use more support than kossel design?
How efficent would this be? Or accurate?
Do I need to use stronger stepper motors?
I think a belt would be best choice?
What's the best software I would like to have three extruders, LCD screen, sd card, ect
I would still like to use carbon fiber rods. Would this still be a good choice?
Going to need a good heat bed that size. Most likely this will be a DIY task what's the best method?
Ok pretty much I'm looking for the best of everything if someone could do a exact parts list and where to get it.
I want to order these parts ASAP and get building.
I seen the Rostock max it's cool but I need a bigger print area.
: ) please help I don't want to waste time and money on poor parts or outdated parts.
Peace
