Hello all,
I bought a 3d touch senor for my delta printer. But I do not get him to work! I'm using a RAMPS 1.4 Reprap board and Marlin VLD 1.1.4-AC. I followed the introduction of the geeetech.com wiki site, but without result.
The cables are connected as recommended and the firmware has been modified as suggested.
When the 3DTouch is first powered up it is starting with the pin up it them goes down/up 2 times while the LED is on solid and it ends up while the LED is off.
I have no clue what is wrong. Who can help me?