Hi All,
I work as a Development Technician / Rework Technician for an Electronics company and as such have the ability to hand build and repair PCB's.
If you have broken your RepRap controller or other PCB (broken off a part, ripped up a track, burned out a chip) then there is a very good chance I can repair your board for you.
Through leaded, SMT, even BGA's - it's not a problem.
Please [PM] me if you need help or advice.
Attaching a link to a picture of the damage may help considerably.
Mick.
Edited 1 time(s). Last edit at 08/06/2013 03:01PM by slymike.
=======================================================
A wise man once told me "Never trust a man who doesn't own a shed!"
=======================================================
Gen 6 daughter board
[
forums.reprap.org]
Mendel PCB heatbed
[
forums.reprap.org]
=======================================================