Welcome!
Log In
Create A New Profile
Home
>
Electronics Folder
>
Stepper Motors, Servo Motors, DC Motors
> Topic
Advanced
Connecting Stepper Motors and Drivers
Posted by
qzai09
Forum List
Message List
New Topic
qzai09
Connecting Stepper Motors and Drivers
December 12, 2016 09:17AM
Registered: 7 years ago
Posts: 1
Hi,
Recently, I would like to try a project with multiple stepper motors. I am trying to connect the stepper motor as shown in the diagram attached. The stepper motor driver used is DRV8825 Stepper Motor Driver Carrier.
Layout.png
Motor A: [
www.omc-stepperonline.com
]
Motor B: [
www.omc-stepperonline.com
]
Motor C: [
www.omc-stepperonline.com
]
Will there be any problem with the connection? Any suggestion is welcomed.
Thank you.
Best Regards,
Qzai09
Reply
Quote
Dust
Re: Connecting Stepper Motors and Drivers
December 12, 2016 03:54PM
Admin
Registered: 13 years ago
Posts: 7,001
Enable need to be tied low, not left floating
With m0,m1 and m2 left disconnected, your running in full step mode, this is probably not desired
Reply
Quote
cozmicray
Re: Connecting Stepper Motors and Drivers
December 13, 2016 01:29PM
Registered: 11 years ago
Posts: 1,049
Make it simple
Put a GRBL board atop your arduino
[
www.synthetos.com
]
[
www.ebay.com
]
12v-30v motor voltage supported
Load GRBL on arduino and start executing g-codes
and spinning the motors
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login