Hi,
I bought a sc42sth47-1648a 1.8 degree 2 phase motor to use with a different extruder setup. When I received the motor, there are 4 wires sticking out of the motor with no connector at the end. I received no wiring diagram for the motor. The wire colors are black, blue, green and red. I looked into the opening they come out of and the red and green come from the right and the blue and black come from the left to exit that opening.. Anyone around that could give me an educated guess or knows the order I should put them into a connector to plug onto a ramps 1.4 board?
Thanks, Vance.
Folger Tech Prussa I3
Arduino 2560 Mega
Ramps 1.4
A4988 stepper drivers
Repetier Host
Slic3r
Marlin firmware