Sourcing stepper motors for Rostock mini pro February 27, 2015 04:14PM |
Registered: 9 years ago Posts: 4 |
Re: Sourcing stepper motors for Rostock mini pro February 28, 2015 05:47AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Sourcing stepper motors for Rostock mini pro February 28, 2015 01:11PM |
Registered: 9 years ago Posts: 4 |
Re: Sourcing stepper motors for Rostock mini pro February 28, 2015 04:19PM |
Registered: 10 years ago Posts: 14,672 |
Re: Sourcing stepper motors for Rostock mini pro March 01, 2015 07:23AM |
Registered: 13 years ago Posts: 7,616 |
Quote
Zxenop
Typo on the wiki then
Quote
Zxenop
any lower limit to that "less torque more precision" rule ?
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: Sourcing stepper motors for Rostock mini pro March 01, 2015 01:38PM |
Registered: 9 years ago Posts: 4 |
Wouldn't mind the wait, but I'm mostly concerned about reliability, if you know a good Chinese shop on eBay for stepper motors, I'm all earsQuote
dc42
But it's often cheaper to buy them on eBay, especially if you can wait for them to be shipped from China.
Does this mean either the software or firmware have control over the acceleration ? I haven't looked at either yet.Quote
dc42
You can use more torque to get higher acceleration, but you don't have to.
Got it, I'll look for reinforcement to the frame once the printer is finished.Quote
Traumflug
Nope. The less torque, the less forces, the less printer frame bending. Printer frames always bend.
Re: Sourcing stepper motors for Rostock mini pro March 01, 2015 02:51PM |
Registered: 10 years ago Posts: 14,672 |
Quote
Zxenop
Wouldn't mind the wait, but I'm mostly concerned about reliability, if you know a good Chinese shop on eBay for stepper motors, I'm all earsQuote
dc42
But it's often cheaper to buy them on eBay, especially if you can wait for them to be shipped from China.
Quote
Zxenop
Does this mean either the software or firmware have control over the acceleration ? I haven't looked at either yet.Quote
dc42
You can use more torque to get higher acceleration, but you don't have to.
Re: Sourcing stepper motors for Rostock mini pro March 01, 2015 04:49PM |
Registered: 9 years ago Posts: 4 |