6 lead motor for RAMPS?

I have this 6 lead Stepper motor 6 volts 0.6 amp.
this is the lead pic
can i use this for the RAMPS 1.4 board? I know that usual motors are 4 leads. but is there any way for me to use this?

Using an unipolar 6-pin stepper in bipolar 4-pin mode is always possible. You just have to find out which pins are the center tabs and leave them unconnected. For this you best measure with a multimeter the resistance between the pins. This should give you 2 groups of three interconnected pins. Within a group you have to leave unconnected the pin which shows the same (lower) resistance to both other pins and connect the two pins which between the highest resistance between them to you controller board.

It remains to see though, whether the motors are strong enough... I have successfully used similar motors for the Z-axis.