Noobie question for 6 wire motor

Hi guys. Is my connection for the 6 lead motor correct? I'm guessing this is the correct way but wouldn't want to take the risk of killing my ramp1.4



Edited 1 time(s). Last edit at 07/02/2014 12:00AM by PeterLim.

What did you base your wiring configuration on?


How to wire a stepper motor: [www.automationtechnologiesinc.com]
Use a LED to identify wire pairs, (3 links): [www.youtube.com] [www.youtube.com] And [forums.reprap.org]
Tips for beginners: Stepper Motors, bipolar series gets up to speed faster than parallel [www.youtube.com]
Determining what wires to pair up on a stepper motor. Match coils for 8 wire stepper. [reprap.org]
Calibration of stepper motors [www.youtube.com]
How to measure Stepper Motor Voltage [forums.reprap.org]
POTs Calibration – RAMPS 1.4 [bootsindustries.com]
Tuning and Speeds – Adjusting the Machine's Axes for Maximum Speed, (Kit Supplier) [solsylva.com]

Sorry i dont really get your question?
Just a general motor connection for my X, Y and Z axis

... you can identify the coil-wiring by their resistance - the 'middle pin' should measure half the value to the both outer pins ...

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]