Hi all.
I have reprap chinese printer with board marked as "Melzi Ardentissimo" with ATMEGA1284P/AU1328.
After extruder upgrade i decided to update firmware.
as i got from reprap wiki - with this board i can use firmware for Melzi.2.0
i've downloaded Sprinter, changed config to
// Sanguinololu 1.2 and above = 62
#define MOTHERBOARD 62
,
changed callibration and did upload.
it looks good, but i got some strange bug: all my prints are stops 1-5mm (z) before end of model.
i tryed:
print with sd card
print with usb (pronterface)
print from sd, but with pronterface commands
slice with cura
slice with slic3r
reupload firmware
nothing helps =(
printing fails at same point within one model. another model will fail at other point, i can't see any relations.
what to do? =)
Edited 1 time(s). Last edit at 02/04/2015 06:45PM by ieroglif.
