need help to program sanguinolou April 25, 2014 02:52PM |
Registered: 10 years ago Posts: 4 |
Re: need help to program sanguinolou April 25, 2014 03:55PM |
Registered: 13 years ago Posts: 7,616 |
Quote
alan-oz
All it does when it is powered is to move the x and y motor a few steps in each direction and back again. So the board must have a boot loader!
Quote
alan-oz
I have tried to compile sprinter It reports an error Cpp:28:/pin.h:439:3 .
Quote
alan-oz
It will compile using 2560 mega !
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: need help to program sanguinolou April 25, 2014 09:00PM |
Admin Registered: 13 years ago Posts: 7,008 |
Re: need help to program sanguinolou April 26, 2014 04:34PM |
Registered: 10 years ago Posts: 4 |
Re: need help to program sanguinolou April 27, 2014 06:20AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |
Re: need help to program sanguinolou April 29, 2014 01:48PM |
Registered: 10 years ago Posts: 4 |
Re: need help to program sanguinolou April 30, 2014 08:29AM |
Registered: 13 years ago Posts: 7,616 |
Generation 7 Electronics | Teacup Firmware | RepRap DIY |