First does this look right? See images. I havent finished yet Im at [reprap.org]
I wanted to do the atx connection but I dont know how that fits on to my board. The 4 prongs of the atx connection do not line up to anything. So I started doing the instructions for the screw terminal. Is there something I am missing?
Also how well do you need to solder these parts? I learned how to solder while working on this...so it may not be perfect.
Oh and does the voltage regulators just hang off the bottom like mine?
I believe the image you are referencing is for the rev 1.0 board . The latest versions replace it with a voltage regulator. My guess is that it was drawing 5V from it - but now it down-converts the 12 volts from the 2 X 2. I use a right-angle connector on mine.
yes,, your right that looks like a older board. I just soldered everything together I also put on the right angle connector. I missed The AUTO-RST jumper. I presume I can just put a jumper shunt onto it. I didn't fully understand what this does.... when the shunt is on it wont be interrupted when the USB is unplugged which is good for sd card printing? that sound right?
I'm aware only of its relationship to the SD card. I'm very new at this as well and am still working on getting my board loaded with Firmware. The Auto-RST jumper was pointed out to me by another member - I missed it as well initially. If you have the hardware, I'd make it a jumper.