One of the complaints I have heard about Cura (or about most of the other "user-friendly" slicers, for that matter) is their dimensional inaccuracy. Nophead likes to use Skeinforge for that reason, but I have found Skeinforge to be rather user UN-friendly. I have read, however, that older versions of Cura used Skeinforge embedded into them.
1) Does anyone here happen to like the older "Skeinforge" versions of Cura better than the newer ones?
2) If so, is one of the reasons better accuracy?
3) How difficult are the older versions to use, vs. the newer ones?
4) What is the last version of Cura to use Skeinforge?
5) Is that last "Skeinforge" version more, or less, user-friendly than earlier versions?