Welcome! Log In Create A New Profile

Advanced

Printing border/circle/perimeter

Posted by rcboosted 
Printing border/circle/perimeter
April 06, 2016 09:24PM
I can't remember what the term is called so I have a hard time googling it. Basically there was a setting to print a perimeter around the object that is not part of the object on first layer. So if I was printing a 10mmx10mmx10mm cube, it'll print maybe a 16mmx16mm square first, then print the cube inside it. How can I turn this on? I can't find it in ReplicatorG under Skeinforge. I'm printing without rafts.
Re: Printing border/circle/perimeter
April 06, 2016 09:30PM
nevermind, found it, it's called a skirt.
Sorry, only registered users may post in this forum.

Click here to login