Welcome! Log In Create A New Profile

Advanced

Strange Flow Rate in Fillet Plugin

Posted by martblek 
Strange Flow Rate in Fillet Plugin
August 12, 2015 10:13AM
hi all,
if i use in fillet plugin Arc Point or Arc Radius, values for Extruder is too high.
Arc Segment and Bevel seems to be good.

Arc Point
M101
G1 X110.96 Y113.3 Z0.25 F1470.0 E3.728
G2 X111.31 Y113.15 Z0.25 I-0.0 J-0.51 F1470.0 E42.045
G1 X113.15 Y111.31 E66.423
G2 X113.3 Y110.96 Z0.25 I-0.36 J-0.36 F1470.0 E104.706
G1 X113.3 Y86.91 E131.819
G2 X113.09 Y86.7 Z0.25 I-0.21 J0.0 F1470.0 E166.219
G1 X86.91 Y86.7 E191.475
G2 X86.7 Y86.91 Z0.25 I0.0 J0.21 F1470.0 E221.109
G1 X86.7 Y113.09 E237.385
G2 X86.85 Y113.15 Z0.25 I0.09 J0.0 F1470.0 E271.819
G1 F798.0
G1 E271.819
G1 F1470.0
M103

Arc Radius
M101
G1 X110.96 Y113.3 Z0.25 F1470.0 E3.728
G2 X111.31 Y113.15 Z0.25 R0.51 F1470.0 E42.045
G1 X113.15 Y111.31 E66.423
G2 X113.3 Y110.96 Z0.25 R0.51 F1470.0 E104.706
G1 X113.3 Y86.91 E131.819
G2 X113.09 Y86.7 Z0.25 R0.21 F1470.0 E166.219
G1 X86.91 Y86.7 E191.475
G2 X86.7 Y86.91 Z0.25 R0.21 F1470.0 E221.109
G1 X86.7 Y113.09 E237.385
G2 X86.85 Y113.15 Z0.25 R0.09 F1470.0 E271.819
G1 F798.0
G1 E271.819
G1 F1470.0
M103

Last version i hope.
( 13.02.18 )
( 15.08.12|19:7 )
[Solved] Re: Strange Flow Rate in Fillet Plugin
August 22, 2015 07:19AM
Sorry for bothering.
I found error.
Coz i write new gui for skeinforge and tested new fill plugin i rewrite some tag in settings like 'At Middle' > 'at Middle'.
Sry for this sad smiley
Sorry, only registered users may post in this forum.

Click here to login