Welcome! Log In Create A New Profile

Modeling my own scaffolding

Posted by fizgig10

fizgig10

Modeling my own scaffolding
June 02, 2014 05:57PM

Registered: 9 years ago
Posts: 1

So I've modeled my own scaffolding as skeinforge doesn't seem to do it effectively. You can see it in the attached picture (upside down).

My question is how thin should I make the walls so that skeinforge doesn't try to fill them in but treat each wall as just a single pass on each layer?

Reply Quote

Attachments:
open | download - Capture.PNG (86.2 KB)

ahmetcemturan

Re: Modeling my own scaffolding
June 03, 2014 01:53AM

Registered: 13 years ago
Posts: 202

If you are using Original SF: Layer Height x Edgewidth over Height
If using SFACT: Edge width
If it is not extruded make it 25%wider..

Manufacturer of low tolerance Filaments PLA, ABS, ASA, PETG, TPU, PA, PVA,
[www.miafilament.com]
[github.com]

Reply Quote

palawanisland

Re: Modeling my own scaffolding
June 21, 2014 08:50AM

Registered: 9 years ago
Posts: 6

hi! did your manually create scaffolding / support work?
can you post the specs so that i dont have to experiment on settings and size.
smiling smiley