Im fairly new to Skeinforge and replicator, been using Slic3r so far.
but now i got a Makerbot Replicator 2 and would like to use ReplicatorG.
pretty much got the hang of it, but i cant get skeinforge to load the gcode intro replicatorG ones its done slicing. it only loads the start and end code.
so far i have copyed the exitrusion gcode part from the gcode file.
but its not a sufficient as having skeinforge do it.
does anyone have a suggestion on how to solve this problem?
thanks in advance
Edited 1 time(s). Last edit at 04/20/2013 03:11PM by Troest87.
