Hi All,
I downloaded the skeinforge settings for my Orca from mendel-parts.
However, all my prints start with moving to the start of the skirt and than put the extruder in reverse for some 5 CM of folament.
So the extruder is empty and the filament will not go back in due to deforming. Printing than starts on normal feed, with empty extruder.
What parameter dos this ? Or which Gcode statements can I look for to remove ?
I can not locate the problem.
Objects sliced wth Slic3r do not have this problem.
rgrda, Thomas
www.3daybreaker.blogspot.com
Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)